PogoPin PogoPin Installation Precautions

　　PogoPin PogoPin Installation Precautions

　　(1) The gas spring piston must be installed in a downward position. Do not invert it. This can reduce friction and ensure the best shock absorption quality and buffer performance.

　　(2) Determine the installation position of the fulcrum is the guarantee of whether the gas spring can work normally. The air spring must be installed correctly, that is, when it is closed, let the air spring move on the center of the structural center, otherwise, the gas spring will often open the door automatically.

　　(3) The gas spring should not be affected by the tending or horizontal force during work. Do not use it as a handrail.

　　(4) In order to ensure the reliability of sealing, do not damage the surface of the piston rod, and do not apply paint and chemicals on the piston rod. The air spring is not allowed to be installed in the required position before spraying.

　　(5) Air spring is a high -pressure product. It is strictly forbidden to analyze, bake, and crush at will.

　　(6) Do not go to the left rotating sprout springs. If you need to adjust the direction of the joint, just turn it to the right.

　　(7) Environmental temperature: -35 ℃ ～+70 ℃. (Special manufacturing 80 degrees Celsius)

　　(8) Flexible installation of the connection point, no card resistance.

　　(9) Reasonable size and appropriate force. The size of the piston rod is 8mm.

Read recommendations:

M1575 1.2x15.8

Electronic spring contacts M059 2.0X10.7

POGO PIN!pogo pin socket Manufacturing

Application of pogo pin pogo pin in industrial robot

Pogopin spring design attention and rolling forming method